Hi all,
Just thought I'd share a tip. I stripped down a reel recently including removing the shields from some bearings (the clipped-in style).
After greasing a particular bearing it took my nearly 20 minutes to find one of the clips... finally found it clinging to a magnetized screwdriver I'd been using. >:(
Cheers, BigT
Be careful not to magnetize a bearing, it may attract unwanted(and almost impossible to remove) particles.
Thanks Jimmer.... very good thought. I'm off to get some new screwdrivers.
BigT
A little blue grease on the screwdriver tip will help hold a screw, and it gets a little grease in the slot too.