>:( Does anyone know of other screws that fit the freespool lever on the 113 s's???? other than the one that looks like a hex head nut,!!!!Seems like someone else has done this before and Penn makes a lot of models.
I'd just like a simple oval head slotted screw...... and don't want a zirk fitting on the end like a backhoe!!!! thanks gstours
yes, penn 209 uses a screw with locking washer
:) thanks Harry, I'l get several ordered next order.......thanks for the reply>>>>>>>gstours
gstours,
You may also have to change the eccentric. They aren't interchangeable between many models, but I was able to swap the eccentrics and bolt/screw between an 85 and a jigmaster and it worked. I have a Chinese jigmaster that has a bolt without the zirk fitting, so they must be available somewhere. However, it is still a bolt, not a screw. :( If you want something really large and gnarly, install a 23-60 handle bolt on the lever. ;) Yes, it will fit, too!
George