I'm making up some Plinths for Bluefish. What is the width, center to center of a 3 and 4/0 Black, reel clamp bolts? I don't have either. Don't know if the H series is the same or not.
30-113= 1 3/8" (1.375").
Thanks Tom. ;) What about the 3/0 Black? Anybody?
FWIW the 30-66 (112H) is identical to the 30-113.
Daron, the 30-66 is 1.400" on center. With calipers and eyeballed.
Bob
Thanks Bob. ;D
I hope I am not being taken offensive when I point out that it would take quite an eye to tell the difference between 1.375' and 1.400'. I'd say they are the same.
Ron
Only depends on how much you had to drink! ;D right you are!
I think you are right Ron.
I had a double Bushmills before I measured mine using a tape measure ;)
Remembered that the old Penns were Imperial and usually quoted spool widths and plate diameters to the nearest 1/16 inch.
Anyway we'll not argue over 25thou .
Now it's all gone Metric.
Still waiting for someone to measure a 30-112 Stand for the OP.
Guess it's the same as the 112H.
Good Luck with the Plinth Shark Hunter.
The stand for the 112 and 112H are totally different. I can measure this evening, which is early tomorrow morning for most of you.
Ron
The stand for the 112 is different from the 112H but the hole pattern is the same. Center to center is approx 1 3/8".
John
I'll drill both of them at 1 3/8". Thank you Gentleman! ;D