I just picked up a 30-49 sized Newell stand that will probably end up on my BayMaster. Unfortunately it doesn't have a clamp. Any recommendations for a replacement?
Thanks
Ron
What is the spacing between the two screws for the rod clamp? On my way offshore so I will check later today.
Unfortunatly, it's in the mail. It is the stand for the 501 and narrow Surfmasters, etc. If it is close to Penn specs I may just get one of those or maybe an Accurate of the Bay. I just like asking here first.
Thanks
Ron
that sounds like it may be a clamp from Newell 229. Once you get it, measure it and let me know. I purchased a 229 clamp by mistake (wanted a 220). You can have it for what I paid for it if it fits.
Bryan
Cool, I'll let you know. Tracking says it will be here by Fri.
Ron
The 229 and 332 are the same clamp if that helps locate one.
I believe the Penn 30-49 stand is the same width as a Newell 220. I am not sure if the hole pattern is the same or not on the 220 and 30-49 stands. The small BayMasters use a different stand (30-180 and 30-180S) but I believe a 30-49 stand will fit. The 49 stand has the holes for attaching a clamp the 180 stands do not.
John
Thanks John.
You are correct, and it took me several years to figure out, the Baymaster has a Beachmaster type stand that will fit the 30-49 stand of all the other clamp equiped narrow reels.
I'll look for a 332. Does anyone know if a Penn clamp will fit?
Ron
Here is a Penn #33-49 rod clamp on a narrow Newell stand. Use one of these until you find a Newell clamp.
(http://i1162.photobucket.com/albums/q523/rumbum01/P1010510_zps064ac3f9.jpg)
At this present time I am holding a Penn Reel Seat that fits a Newell 220. Penn # 30-180s.
Mike
Great!
Thanks everyone.
Ron
Ron
If you are really stuck just give me the center - center of the screws & I will take one off one of my reels.
Aluminum or Graphite
Mike
Thanks Mike but I think I got this. If what I have doesn't line up I'll buy Bryan's off him so he doesn't have it kicking around.
Ron