www.prochallenger.com
- Made with aluminum T6061-T4 (with heat treated for Harding)
- Off set bent in
- Overall length is little over 4.35 inches
- 4mm thickness
- Handle lock screw included. Please note that lock screw will fit one side on the handle only
- This handle bar will fit the following PENN reels:
9M
10 Mag
12T, 12LT, 12H
14
25, 26, 27
49L
60, 65, 66, 67, 68
77, 78, 79
80 (Conv.)
85
99, 109M
110, 111, 112
112H
113
125
130 (Sailfisher)
149L
100M, 140L, 145, 146L
150, 155L, 160L, 165
180, 185 Baymaster
190 (up to 1990)
200M
209M, 209LC, 210M
250, 259
267, 268, 285M
309M
310GT
350M
500, 501
500S
505HS, 506HS
113H
=============
113HSP
20, 20T
25GLS
30, 30T, 30TW
30S, 30SW
30VW (Older and Newer)
40GLS, 45GLS
50, 50T, 50TW, 50W
50S, 50SW
50VW
113H, 113HL, 113HLW, 113HSP
113MTL
220GTO, 230GTO (Also needs one 110-60 locking screw)
225LD, 245LD, 246LD
320GT, 321GT
320LD
320GT2, 321GT2
320GT2LC
330GT, 330GT2
340GT, 345GT
340GT2, 345GT2
349, 349H, 349HC
970, 980, 990
TRQ300LD
Great looking handle arm Alan! 8)
Can somebody give me the hole diameter for these blanks? thanks
For the knob?
Quote from: LanceV on February 14, 2023, 11:44:33 PMCan somebody give me the hole diameter for these blanks? thanks
The knob hole diameter is 0.183" pr 4.65mm
Thanks blackpearl