Double dogged Lefty 501 Jigmaster

[Petah]

Inspired by Alan C's bridge plates!!!


Tib frame and handle, Bryan's 5+1 drag stack, Accurate side plates and one of Alan T's s.s left hand thread gear sleeves.

[Marcq]

Looking good 

Marc..

[mhc]

Keep it coming Peter, it's always good to see more dogs on the bridge and different ways to put them there. Is the extra post on this one a PEM clinch on pin like you used on the squidder? I might have to look into those, are they pressed into place?

Mike

[Gfish]

That is one tough lookin jiggy! Nice job wtih the E-clip dogs. Dogs liftin up and spring adjustment's been a problem for me. I've even superglued a few dog springs in place.

[Petah]

Mike,
       Yes, they're the same pins:

McMaster-Carr
page 3439
Clinch-on Pins for Sheet Metal

PEM Tps-125-6, 1/8" Diameter, 3/8" Long
95648A400
1
Pack of 50
$11.79
Clinch-on Pins for Sheet Metal

PEM Mpp-2mm-5, 2mm Diameter, 5mm Long
95648A320
1
Pack of 25
9.03
Merchandise 20.82
Sales Tax 1.98
You can press them (probably best way) or I used a punch and hammer!

[mhc]

Thanks for the details, I should be able to find them or something similar over here.

Mike