Sx raptor question

[Ande]

Hi I'm new to this forum so sorry if I post this wrong .I have a sx raptor .I took it apart to clean and lube all tutorials I have watched were for sx or sxj .they show two thrust washers between the spool bearing and drag bearing .my sx raptor only had one I thought it was stuck to bearing but no only one .I looked on avet site at schematic # 17 it is difficult to tell if it's one or two .the sx schematic clearly shows two .I can't believe I lost it because I was working on my table .this was first time it was taken apart . Does anyone know if the sx raptor only has one thurst washer ?

[alantani]

they typically have two, but they are not critical at all.  if you only have one, place it between the right spool bearing and the spring.