Pre Service A New Reel

Started by Corroded, December 06, 2018, 03:31:51 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Corroded

 I ordered an accurate tern 500 and having owned an accurate before I learned that it will need some pre service before I take it out and fish with it. After looking at the photos of the reels guts on accurates website it looks alot like a newell. What kind of preservice procedure would you guys recommend so I can have the maximum corrosion protection for my reel? I have some teflon marine grease I was thinking of coating the inside with. Minus the bearings (corrosion x) and drags (cals). Would this be bad to use in a star drag because it would somehow affect the engage of the pinion? Would it make the internals too sticky? Ive done this to my lever drag but I am just unsure of how it will affect the numerous parts of a star drag clutch system.

Dominick

Leave the gun.  Take the cannolis.

There are two things I don't like about fishing.  Getting up early in the morning and boats.  The rest of it is fun.

Gfish

Not certain with the new Tern, but I believe Accurate does the protective treatment at the factory using Cal's grease.
Fishing tackle is an art form and all fish caught on the right tackle are"Gfish"!

Swami805

It's like the old saying "chicken soup, it couldn't hurt"
Do what you can with that you have where you are

Corroded

#4
Quote from: Dominick on December 06, 2018, 03:34:51 AM
Go here you should find the information.  http://alantani.com/index.php?board=10.0 Dominick

There are no service procedures yet for the tern. I understand their lever drags but their new star drag is very different inside.

I also checked the newell section since i found out its very similar to a newell internally but Alan didn't apply any type of grease to the clutch plate or areas connected to it except for the drag stack. http://alantani.com/index.php?topic=24.0

Thats why i came here to ask. Would it affect the mechanics of the whole system moving properly? I had a similar issue in my calcutta TE series which i used in the saltwater. I tried to coat the sideplates and internal parts(minus the plastic gears/parts) with grease and it caused a sticky clutch engagement issue. Im just wondering if any of the newell guys have this problem?

Link below is from the accurate website showing the internals of the tern series.

https://www.accuratefishing.com/tern/#iLightbox%5Bgallery_image_1%5D/4

Swami805

I still fish with several Newells and use a marine grease with no issues, if your grease is gummy maybe thin it a little. That said a Tern might be different but I don't know why it would be. I assume it comes greased, maybe have a look and if the grease looks adequate leave it be.
I read some where about a quirk in the way it goes into gear from free spool, don't remember exactly what. You notice anything?
Do what you can with that you have where you are