alan tani @ alantani.com fishing reel repair rebuild tutorial Cabo 100 repair question
Reel Repair by Alan Tani
October 13, 2019, 03:54:03 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
 
   Home   Help Search Login Register  
Pages: [1]   Go Down
  Print  
Author Topic: Cabo 100 repair question  (Read 1062 times)
0 Members and 1 Guest are viewing this topic.
El Cazador
Member
*
Offline Offline

Posts: 2


« on: June 30, 2019, 03:31:54 AM »

I have 4 Cabo 100's

2 of them have started to stick, one at the top dead center & one at bottom dead center of rotation.

I have tried replacing the following (with no success)
- Shaft
- Pinion/drive gear
- O/S slider assembly

I have disassembled (multiple times...arggg!)/cleaned & greased

Could it be the O/S gear? if so, (after screw is removed) how do you remove that gear?

Thanks for your help in advance.
Logged
Rivverrat
Member
*
Online Online

Posts: 2233



« Reply #1 on: June 30, 2019, 05:39:02 AM »

 These are good reels & worth the effort to keep going in a lot cases. I'm sorry to say it's been a while since I've been inside one. Some one will be along shortly to help you sort this... Jeff
Logged
alantani
admin
Administrator
Member
*****
Online Online

Posts: 17733



« Reply #2 on: June 30, 2019, 06:57:19 AM »

i wish i could help.  i might be best to just send these in to zebco......   Undecided
Logged

send me an email at alantani@yahoo.com for questions!
El Cazador
Member
*
Offline Offline

Posts: 2


« Reply #3 on: June 30, 2019, 04:49:38 PM »

My heart sinks....when I see YOUR post... Sad

Ok, I will send  back & will report back what command central reports :
Logged
alantani
admin
Administrator
Member
*****
Online Online

Posts: 17733



« Reply #4 on: June 30, 2019, 07:17:33 PM »

well, for something like this, i wouldn't go just by me.  spinning reels take a certain mind set, and it's something i just don't have.  we have a couple of guys here that work on them quite a bit.  it's just that they change up so fast, year to year.  really tough to keep up!
Logged

send me an email at alantani@yahoo.com for questions!
Three se7ens
Sensei
Member
***
Online Online

Posts: 1265


WWW
« Reply #5 on: September 10, 2019, 05:35:40 PM »

Id bet you got the shims mixed up, and the main and pinion gears arent meshing properly.  What sucks is, at this point, all you can do is experiment until you find what was right.  Its a tedious process, but can be done.  The shims will go between the main bearings and the main gear, and on top of the front pinion bearing.

https://www.quantumfishing.com/partsfinder put in your model number to see the schematic and parts list. 
Logged

Pages: [1]   Go Up
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines
Simple Audio Video Embedder
Valid XHTML 1.0! Valid CSS!
Page created in 0.189 seconds with 19 queries.