Shimano Stella Bail Arm Assembly required.

Started by Irish Jigger, May 28, 2020, 05:05:43 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Irish Jigger

I need a new or used Bail Arm Assembly RD 8140 for a Stella  4000FA (2003).
This part is discontinued and I have tried unsuccessfully to find one.
Any help or advice would be greatly appreciated.

alantani

send me an email at alantani@yahoo.com for questions!

Alto Mare

Hello Tom, that's going to be a tough one.
I'm going to look around and see if I get lucky.

All my best,

Sal
Forget about all the reasons why something may not work. You only need to find one good reason why it will.

Irish Jigger

Many thank,s to Alan and Sal.
I really appreciate your help but am more or less resigned to never finding the part.
I have decided to take another look at the damaged bail arm.
I feel that using the experience gained and ingenuity shown on this forum over many years I can get it fishing again.
I shall keep you posted.

Alto Mare

Quote from: Irish Jigger on May 29, 2020, 10:13:50 PM
Many thank,s to Alan and Sal.
I really appreciate your help but am more or less resigned to never finding the part.
I have decided to take another look at the damaged bail arm.
I feel that using the experience gained and ingenuity shown on this forum over many years I can get it fishing again.
I shall keep you posted.
Tom, you have added a lot to this forum and I will never forget.
I'm very happy seeing you back on.

Sorry  no luck on that part, I've seen a few but not for that reel.
If anyone could make that bad part work, it is you.

Later Tom,

Sal
Forget about all the reasons why something may not work. You only need to find one good reason why it will.

mhc

Good to see you Tom, I've used a few of your ideas over the years.
I had a quick look on ebay Australia without luck.

Mike
It can't be too difficult - a lot of people do it.

Zimbass

Hi Tom,

I'm not into spinners generally, but do have a couple of bail arm assemblies that might be correct.

Are you able to give me some measurement, and I can see if it what I have.

PM me if you wish.

Best,

Terry,
Never was so much owed by so many to so few.

Irish Jigger

Hi Terry,pm sent.
Thank's for the welcome back guys.
Tom.

Zimbass

#8
Hi Tom,

Don't know how to send pictures on messages, so have added here.

The unit looks very similar to that I've seen on the web, but, the wire on the one I have is thicker at 2,5mm.

Not sure what you think.

Let me know.

Best.

Terry.
Never was so much owed by so many to so few.

Irish Jigger