Penn Levelwind 309 Spool

Started by Gfish, April 21, 2021, 01:44:45 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

oc1

#15
In desperation, you could put tiny brass washers between the posts/stand and the rings.  It will widen the frame.  I've seen the washers at the local hardware store.

Wompus Cat

After looking at all the shimming bending and stuuf you have done on this ,you may have a Frankenreel!
Need to get a known Good 309 and compare measurements to get a mean to go by.
If a Grass Hopper Carried a Shotgun then the Birds wouldn't MESS with Him

thorhammer

Greg I wonder if that hasn't been "repaired' with an LB 65 spool.

Mic

GFish,
Took my 309 apart and it would appear my spool is the same as yours. A three piece spool that appears to be able to be separated by the hex nuts on both ends once the snap ring clip and gear are removed

No part number on mine either. Looks like this type of spool could be used for several different reels if the center bushing was replaced by wider or narrower piece ? Maybe/Maybe KNOT

I can get measurements if it if needed

Mic