Long 5 or 6 inch power handle for 12/0

Started by SeaDragon, September 06, 2021, 02:34:07 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

SeaDragon

I am looking for an extended handle for a 12/0, (5 or 6 inches) or can someone open up a 6/0 9/0 handle hole to accommodate a 10/0 12/0? Also I'm guessing if we do this a stainless sleeve may be necessary? Thanks.

Swami805

Pro challenger on here makes an offset handle for 10/0 to 16/0, might be worth a look.   125 MM
Do what you can with that you have where you are

SeaDragon

I talked to Alan at Pro Challenger but that handle is only 1 1/4" longer.

Shellbelly

I have an older, but clean 5.5" power handle from a 114H.  It has 3 sizes of mounting holes and a 3.75" black plastic handle mounted at 90 degrees.    I can't get the lock screw off my old 12/0, but I believe the nut is the same for the two models.  Used, but not corroded and certainly not jazzy.  No maker on it and the handle grasp has about 1/8" end play.  The peening is tight so I believe that's how it's made so it will spin freely.  Trade for a 80's era 114H handle in like condition?
"Little boy,  you can get glad in the same pants you just got mad in."  (My Momma)
"You shot it boy, you're gonna clean it and eat it".  (My Dad)