alan tani @ alantani.com fishing reel repair rebuild tutorial Shakespeare 2200ck Sigma 060 Replacement fiber drag washers
Reel Repair by Alan Tani
September 18, 2021, 08:41:57 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
 
   Home   Help Search Login Register  
Pages: [1]   Go Down
  Print  
Author Topic: Shakespeare 2200ck Sigma 060 Replacement fiber drag washers  (Read 183 times)
0 Members and 1 Guest are viewing this topic.
dpabrams
Member
*
Offline Offline

Posts: 11



« on: September 07, 2021, 11:00:16 PM »

I have a 2200ck Sigma 060 that needs the fiber drag washers replaced. I can't find the original fiber washers and I am wondering if there is a generic replacement. Any ideas?

Thanks,

Pete
Logged
Ruffy
Firearms Group
Member
**
Online Online

Posts: 268



« Reply #1 on: September 08, 2021, 02:51:56 AM »

Hi Pete, can you measure yours? Then find something close from smooth drag (https://www.smoothdrag.com/wp/carbontex-washer-sizes/). Thickness is probably most important, just remember the inside diameter can be widened, and the outside diameter cut down.

On an 050 which I had, I used the #8 in 1mm thick for the three washers in the spool, and the washer underneath the spool. Not sure if this will correspond to the 060 though.

Cheers,
Andrew
Logged
dpabrams
Member
*
Offline Offline

Posts: 11



« Reply #2 on: September 08, 2021, 10:05:34 PM »


On an 050 which I had, I used the #8 in 1mm thick for the three washers in the spool, and the washer underneath the spool. Not sure if this will correspond to the 060 though.

Cheers,
Andrew

Thanks Andrew, I just need to get the measurements and should be able to locate the washers after market.

Pete
Logged
Brewcrafter
Member
*
Online Online

Posts: 864


« Reply #3 on: September 09, 2021, 06:37:00 AM »

Pete - In my experience opening up the ID is easier than tightening down the OD.  I have used Smooth Drag many times, and they have a great chart of specs for 'non-stock" apps.  If you can find one that is close, I find that bits for "step drills" work great to open up the ID if you use them by hand (not in a power tool).  Usually the cutting surface is sharp enough on a fresh bit that you can twist it by hand and open up the ID.  A little messy, yes but you will have nice clean concentric circles.  Hope this helps. - john
Logged
dpabrams
Member
*
Offline Offline

Posts: 11



« Reply #4 on: September 09, 2021, 01:57:48 PM »

I found stock fiber washers that are on order. We will shall see. Thanks for the interest.

Pete
Logged
Pages: [1]   Go Up
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines
Simple Audio Video Embedder
Valid XHTML 1.0! Valid CSS!
Page created in 0.09 seconds with 20 queries.