Started by WVHillbilly, August 07, 2022, 07:48:14 PM
0 Members and 1 Guest are viewing this topic.
Quote from: WVHillbilly on September 27, 2022, 11:15:40 PMWeather is cooling down, and bean coming up to speed so I plan to get back on this very soon. I have another chunk of material, but may try to still use the mess up. I may have no real choice but to make a jig to make sure everything stays and locates. My primary screw up was that inside chamfer. I should have left the edge square and dealt with at chamfer later. It was just to allow clearance for the metal side plate rings. Worse case is I turn it into cross bars
Page created in 0.062 seconds with 20 queries.