Started by Finest Kind, May 20, 2023, 09:49:41 PM
0 Members and 1 Guest are viewing this topic.
Quote from: Maxed Out on May 24, 2023, 06:35:42 PMYokes have rounded off edges on one side, and squared egdes on the other. The rounded edge side goes up when installing. If it upside down, the pinion will grind on the square edge Ted[/quoteOh OK. The funny thing is, on the SS yoke, I could not tell which side was which. They both look rounded and very smooth. Definitely nicer than the standard brass. But I did try it both ways and that didn't help. Also switched back and forth with the original brass yoke that was in the reel. No dice!
Quote from: JasonGotaProblem on May 24, 2023, 06:42:11 PMI have a few external drag sideplates. If you screw it up i can give you another for the cost of shipping.
Quote from: Keta on May 24, 2023, 11:12:52 PMIt only takes a few minutes.
Quote from: Keta on May 26, 2023, 09:35:54 PMUse a Dremel to extend the slots.
Page created in 0.087 seconds with 19 queries.