Started by johndtuttle, August 08, 2012, 08:19:31 PM
0 Members and 1 Guest are viewing this topic.
Quote from: Clem on August 09, 2012, 11:33:41 AMExcellent John...is this the reel you upgraded with bearings on the worm shaft
Quote from: paal on August 09, 2012, 12:29:21 PMVery nice John! No need for a lot of pictures, servicing this reel is probably not for beginners anyway. They are better off practising on e.g. a Spheros first I tried to use this little guy to oil the line roller, the needle fits just inside the "oil cap tube":But it was difficult to assess how much oil actually went in. Probably too much, because it was oozing oil when I fished it afterwards.... I also noted when taking the roller assembly apart, that there were "voids" on both sides of the line roller bearing. I'll keep an eye on whether water can get in. I'll bet it can on the "oil tube" side, not sure about the other side of the bearing. An option might be to fill the voids with marine grease, at least it will minimize the amount of water that can get stuck in there. Time will tell, for now I'll just be inspecting for water from time to time. And give it the regular fix of oil through the port tight lines,Paal
Quote from: spearo776 on August 29, 2012, 10:35:43 AMwhat are your overall thought on the stradic fj's. looking at getting a few more mid sized spin reels. or would you spend the extra on a sustain??
Quote from: alantani on August 29, 2012, 05:50:40 PMjohn, send me a pm with your address. i'd like to send you a wrench!
Page created in 0.078 seconds with 18 queries.