Daiwa Sealine 350

Started by ericjp, September 14, 2009, 05:03:51 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

ericjp

Alan,

Do you know if the drag washers are the same as the 400\450?  I've looked through the schematics from Daiwa and can't tell.  The drag washers look like the ones in your tutorial. 

Thanks,

Eric

alantani

you know, i don't.  i don't have a 350 in line, either.  can you pull the drag washers and measure them?  i'm sure we can match them up to something.  alan
send me an email at alantani@yahoo.com for questions!

ericjp

#2
I could only find a ruler to measure them.   The outside diameter is 24mm, inside 14mm, 1.3mm thick?   There is a lot of space between the drag washers and gear sleeve.  I gear sleeve is 13mm.    Do you think these would fit?  #6-875 ($1.25) / 13.06 x 25.01 x 1.23 / 875 line counter, or would it be better to try to find one with a 15mm inside diameter?

Thanks,

Eric

alantani

it is the outside diameter that is important.  sounds like you've got the right one.  alan
send me an email at alantani@yahoo.com for questions!

ericjp

I ended up using the washers for the penn 114.  Perfect fit!

alantani

a #6-114!  that's great!  i'll bet a #6-855 will fit underneath the main gear.  alan
send me an email at alantani@yahoo.com for questions!