Penn 16 VXS

[Nuvole]

Finally found this place that I can post.

Alan,

Thanks very much for this very informative site.

I strip the reel and found 4 small/thin washer which is not in the schematics. They fit roughly the size of the small bearing on the pinion gear, and hence I've place them on both side of the bearing.

Any one can confirm where should these goes to?




http://lh5.ggpht.com/_-10v_xoxGqo/TDEh-TD6hSI/AAAAAAAAAW4/K90cY3Zl0k4/s512/Penn_INT2_VSX.JPG



http://lh4.ggpht.com/_-10v_xoxGqo/TDEh-SZ9diI/AAAAAAAAAW8/lBQb9PvZgzE/s512/Penn_INT2_VSX_small.psd.jpg

[Dave Bentley]

UH OH

[Roger]

 I'm  just gonna take a guess and say they're the shims(8A) on your pinion. The schematic shows 6 of them but I've seen stranger things.

[Nuvole]

Roger,

There's no key no.8A on my schematics. Mind to share where are they place on yours?

[Roger]

Sorry about taking so long. Try this.....

https://www.mysticparts.com/Assets/images/pennparts/schematics/16vsx.pdf



"Edited as per Moderators to correct Scott's Bait & Tackle over to their new store name Mystic Reel Parts / www.mysticparts.com"

[Nuvole]

Sorry about taking so long. Try this.....

https://www.mysticparts.com/Assets/images/pennparts/schematics/16vsx.pdf

Roger,

Thanks very much.

I now see that the schematics(Rev3 11/18/05) that come with mt reel is outdated.

[alantani]

so, is the reel back together yet? 

[Nuvole]

so, is the reel back together yet? 

Yup, all done :-)

[alantani]

very impressive effort!