disassembly Staltist STTL50HA

Started by MuskyFishing, July 20, 2014, 08:04:20 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages1
User actions

MuskyFishing

July 20, 2014, 08:04:20 AM
My very first reel,   and I'm afraid to open it. 
Will parts go flying like fireworks if I take off the covers?
Should I pack the internal parts with grease?
What are  the four holes for?
how much is too much grease?
What to use to  lubricate the levelwind gear/shaft?
How difficult is it to pack the bearings AND REPLACE ALL PARTS PROPERLY AND FACING THE CORRECT WAY?
A diver sees a man at 20 feet without SCUBA gear and watches him going down. 40...50..60...100...150...200  At 300 feet he catches up with the man, grabs his board and writes: "This is Amazing! How can you dive so far without breathing?" The man quickly takes the board and marker from him and writes: "I'M DROWNING YOU IDIOT!!!"

Bryan Young

#1
July 20, 2014, 09:16:29 AM
You may want to give http://alantani.com/index.php?topic=227.0 a look-over. 
:D I talk with every part I send out and each reel I repair so that they perform at the top of their game. :D

MuskyFishing

#2
July 20, 2014, 02:00:59 PM
What are  the four holes for, On the crank side?   ???
There are holes, not threaded for screws   STTLW50HA
A diver sees a man at 20 feet without SCUBA gear and watches him going down. 40...50..60...100...150...200  At 300 feet he catches up with the man, grabs his board and writes: "This is Amazing! How can you dive so far without breathing?" The man quickly takes the board and marker from him and writes: "I'M DROWNING YOU IDIOT!!!"
Print
Go Up Pages1
User actions