Penn Senator 9/0

[Rogve]

I have two Penn Senator 9/0's (one and a half, really)  Both are in pieces. 

All side plates utilize the NEW bearing.

There are two different spools. 



Spool A:  (Assuming the older spool)
Handle side shaft length:  1.070"  (tip to spool) - the older bearing extended further into the reel
Inside diameter (where line spools) .700"
Left side (clicker/non-handle) shaft diameter:  .155"  (+.005" maybe)
THIS SPOOL FITS INTO THE LEFT SIDE (NON-HANDLE SIDE) BEARING (shaft fits into bearing opening)

Spool B:  (assuming the newer spool style:)
Handle side shaft length:  1.390 (makes sense, as the new bearing doesn't extend into the reel)
Inside diameter (where line spools) .830"
Left side (clicker/non-handle) shaft diameter:  .190"  Does NOT fit into the bearing.

THIS SPOOL DOES NOT FIT INTO THE LEFT SIDE (NON-HANDLE SIDE) BEARING (shaft fits into bearing opening)

All the schematics I've viewed show only one left side bearing for all models.

Note:  Both reels are the same width, and the "Bell" or side of the spool are both 3.75" on each spool

Is there a different left/non-handle side bearing???  All other information I can find addresses the change in the spool, the right side bearing, and the spool.  I have not found any information on the left side bearing.

[alantani]

this is all i've seen.  https://www.mysticparts.com/PennParts/Technical/115LDesignChangeRight.aspx

i send a pm to ryan at mysticparts.com

[MysticParts]

Hello Rogve,

Your best bet is to look at the following two pages on our site regarding the design changes for the 115L.

Right Side Bearing: https://www.mysticparts.com/PennParts/Technical/115LDesignChangeRight.aspx

Left Side Bearing: https://www.mysticparts.com/PennParts/Technical/115LDesignChangeLeft.aspx


"Edited as per Moderators to correct Scott's Bait & Tackle over to their new store name Mystic Reel Parts / www.mysticparts.com"

[Rogve]

MOST EXCELLENT!!!!

Thanks much.  I don't know how I could have missed this before....

[alantani]

you and i both missed it.  ryan said it was at the bottom of the page and he moved it to the top!