Trying to find a Penn part

[JRD]

I used to have a few very small diameter keyed washers to fit in jigmaster gear sleeves.  The were great for adding a little drag height without plate clearance problems.  Now I need a few and can't find them on jigmaster or squidder schematics.  Can anybody point me in the right direction?

[RowdyW]

For the Jigmaster it's #86-500 & for the Squidder it's #86-60.      Rudy

[Bryan Young]

I wasn't aware that there were small keyed washers for the jigmaster. Newell had them, and I have cut a bunch.  They are 0.05 mm thick, and they are $3 each because I only had a hundred cut.  I think next time I'll cut a lot more and in 2 or 3 thicknesses to reduce the price a bit.  PM me if you are interested.

Bryan

[bluefish69]

If your going to buy the spacer washers then buy a longer sleeve from Scott's. They come in 3 sizes.

Mike