Bearing puller

Started by Alto Mare, May 14, 2011, 11:18:02 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages 1 2
User actions

ReelSpeed

#15
May 20, 2011, 03:23:16 AM
Sal, got the tool today.  Thanks!  Will try and get some prototypes and pricing tomorrow or Saturday.  I will probably offer a set of the tools in each common size of inch & metric.  Also, instead of a straight spot after the button top, I will make a taper so it presses into the bearing inside diameter and makes a quick pull out.

Aaron
Reelspeed Reel Service & Repair
Santa Fe Springs, CA 90670
(562) 261-5190

Alto Mare

#16
May 20, 2011, 03:30:31 AM
Very good! Thanks Aaron!
Forget about all the reasons why something may not work. You only need to find one good reason why it will.

broadway

#17
May 20, 2011, 04:38:04 PM
Looking forward to see what ya come up with!
Dom

ReelSpeed

#18
May 23, 2011, 10:07:41 PM
Reelspeed Reel Service & Repair
Santa Fe Springs, CA 90670
(562) 261-5190

BassMatt

#19
January 02, 2012, 01:55:20 PM
A strong magnet has worked well in the past for me to remove bearings for most applications.

Irish Jigger

#20
January 02, 2012, 02:12:28 PM
 ???

Alto Mare

#21
January 02, 2012, 02:42:34 PM
 X2 ???
Forget about all the reasons why something may not work. You only need to find one good reason why it will.

Jimmer

#22
January 02, 2012, 03:55:44 PM
I would be careful about magnetizing a bearing in any application, It may cause them to attract and hold impossible to remove metal particles. - Jimmer
What - me worry?   A.E.Neumann

Norcal Pescador

#23
January 02, 2012, 05:49:20 PM
Quote from: Jimmer on January 02, 2012, 03:55:44 PM
I would be careful about magnetizing a bearing in any application, It may cause them to attract and hold impossible to remove metal particles. - Jimmer

X2!!
Rob

Measure once, cut twice. Or is it the other way around? ::)

"A good man knows his limits." - Inspector Harry Callahan, SFPD
Print
Go Up Pages 1 2
User actions