Strip and polish Newell bars?

Started by Decker, September 28, 2017, 01:25:28 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Decker

Does anyone have any experience in stripping down aluminum Newell bars?   

There are a lot of used Newell bars on the market with imperfect finishes.  I thought of stripping down some to the aluminum and polishing them.  I believe the black finish is powder-coating.  There were some partially stripped ones for sale on ebay that appeared to have been sandblasted, showing signed of a red undercoat (maybe red lead).   

I have little experience in this area, but I'm encouraged by what I have seen others do with Penn Spinfishers.  Seems wise to ask if others have experience before taking this on.  Thanks in advance.
And you know that you're over the hill,
When your mind makes a promise that your body can't fill,
Doin' the old folks boogie and boogie we will,
'Cause to us the thought is as good as a thrill...

ez2cdave

Hmm . . . I'm curious to see how this turns out.

I had never thought of stripping and polishing Newell crossabrs, but it does sound interesting !

Tight Lines !

Swami805

They're anodized aluminum. I did one 4 hole handle that was beat up pretty bad. Came out ok but a ton of sanding and polishing, I wouldn't do it again.
Do what you can with that you have where you are