Surfmaster 200

[JasonGotaProblem]

yea.. i forgot to mention that i need
the diameter for the tool to remove that pin...

Ahh very different problem. It doesn't need to be the right diameter . It just needs to be smaller. A finish nail works well. Some folks use a jewelers watch band tool. One fellow I know has a hole drilled at the edge of his bench and he taps it thru with a small nail. All you need to do is get it started and then pull out with a pair of pliers.

[dubsetter]

yap..
it needs to be smaller.. thats why i asked.

i ordered now a 0.9 mm tool (pin punch)

as i have a lot of tweezers, screwdrivers,pliers  etc..
but missed to buy a set of these.

anyway thanx ..
 
i will report when the conversion is done.
(might take a while though, as the bridge /sleeve will
be shipped overseas which will take at least two weeks.)

[dubsetter]

bridge arrived form overseas..
i will convert the antiverse plus sleeve onto my bridge
as mine is nickel plated or stainless steel.
then put it all back together..

takes some time tough, as im on travel at the moment.