Cleaning carbontex drag washers?

Started by Killerbug, August 31, 2011, 10:15:39 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Killerbug

I am looking for an advice on cleaning carbontex washers in case they have been contaminated, either with oil/water or they
have turned sticky by the use of improber grease.
http://forum.esoxhunt.dk
-----------------------------
They say Catch and Release fishing is a lot like golf.
You don't have to eat the ball to have a good time

Bryan Young

I've used carb-cleaner and blowed them dry before apply a clean coat of Cal's grease.

I think Jim had some experience with silicon lubricant migration into drag washers, and I believe he indicated that he could not get silicon lubricants out of the washers and had to replace them.
:D I talk with every part I send out and each reel I repair so that they perform at the top of their game. :D

Killerbug

http://forum.esoxhunt.dk
-----------------------------
They say Catch and Release fishing is a lot like golf.
You don't have to eat the ball to have a good time

alantani

you might also just go in with an old rag and rub till you "raise the grain" and then regrease it.  that alone usually works.  alan
send me an email at alantani@yahoo.com for questions!

Killerbug

Quote from: alantani on September 01, 2011, 03:16:03 PM
you might also just go in with an old rag and rub till you "raise the grain" and then regrease it.  that alone usually works.  alan

Actually I did that already, not out of knowledge, but out of need ;).  Do you think lighter fuel will do any harm to the carbon fiber in case I use that??
http://forum.esoxhunt.dk
-----------------------------
They say Catch and Release fishing is a lot like golf.
You don't have to eat the ball to have a good time

alantani

won't hurt, but might not be necessary either.
send me an email at alantani@yahoo.com for questions!

Jayce

Hi Guys,

Wanted to ask the same question hehehe.

I recently got new cabontex washers (Thanx Dawn and my AZBASS for the help) and
will be moving the old carbontex to another reel but the old carbonex I used another Drag grease
(Tica Drag Grease- green color and smelly comes in small cute containers). 

Im planning to wipe off the grease and then soak them in Lighter Fluid for cleaning. 

Will this be ok or is there a right way ?
What do you guys clean them with ?

Is kinda hard to get carbontex here on my part of the planet.



alantani

carb cleaner or brake cleaner would probably work better, but use lighter fluid if it's all you can get. 
send me an email at alantani@yahoo.com for questions!

Jayce

Thanx Alan  ;D

Hi Dawn,

Will be buying another pack of carbontex soon. 

What pack can fit the Shimano Conquest 101 and the Shimano Scorpion DC7 Reels ?

inhotpursuit


Dawn

Hi
The Conquest 101 = Calcutta TE100
Scorpion Dc7 = Calcutta TE200

Dawn
Dawn

Jayce


alantani

send me an email at alantani@yahoo.com for questions!

Jayce

Yup You said it alan
Never go fishing without her drags.


Dawn

Dawn