10/0 left side plate

[Van]

Anybody know where I can find a left side plate that takes the screw in bearing? I assume I can't use the one with the press in bearing.

Has anybody 3D printed a side plate yet? Seems like a good idea, I wish I could model one to try it but it'd probably take me a year just to figure the software out.

[Swami805]

There's one on ebay

[Van]

That takes the screw in bearing? I didn't see it.

[handi2]

You must be referring to the older 10/0 reel that had the screw in bearing/bushing. That might be hard to find.

[Van]

Well I managed to rough draft the dimensions. I'm not exactly sure how to measure for the lugs or the screw holes though.  

Can't really tell if the bearing screwed in an insert or if it just screwed into the side plate. I see the other side has an insert though.

Then I'll still have to figure the clicker out.