Pflueger 551

Started by CincyDavid, July 30, 2025, 03:34:47 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

CincyDavid

Quote from: Paul Roberts on October 30, 2026, 12:34:48 AMAs to variations in the design...
An FYI, in case someone ever needs to replace 2062/2068/551, etc... drag knobs:

My 551 is missing the top cap on the drag knob. Knob still functions, it's just an aesthetic issue. I did not expect to find a replacement (with the Pflueger 'P' on it) so I kept my eyes open for a Shakespeare 2062 knob. Found one a while back and...it didn't work. I assumed the threads were damaged as it would not thread down far enough to contact the drag stack. Roll ahead a good while and I found another 2062 knob. It too failed to thread down far enough. Apparently, the two reels cannot use the same drag knob?

So, I did what I should have done in the first place, I tried a knob from one of my 2062's and...it didn't fit either. It would thread on, as if threads counts are the same, but would not thread far enough to engage the stack. I then tried swapping drag knobs across two 2062's, a 2068, and the 551. Only one of them interchanged -the one from the 551 that is missing its end cap!

It appears that the drag knobs are each slightly different heights. I don't think the drag stacks are missing anything bc all 4 reels work, but only with their respective drag knobs. Looking closer, the knobs are not all the same height. Perhaps they were ground down for a custom fit at the factory? That would be understandable if the machining specs of the time weren't able to provide tolerances for adequate drag adjustment.

Apparently, a previous owner of my 551 had lost the original drag knob. A replacement did not work! So they knew enough to pry the cap off the replacement knob to allow it to seat onto the drag stack.

Who'da guessed?
Paul, now I'm intrigued, I'll have to try some mix-n-match of drag knobs and see what happens.