Penn 1/0 Corrosion Explosion

Started by sandbar, September 20, 2026, 07:48:22 PM

Previous topic - Next topic

bja105 and 1 Guest are viewing this topic.

sandbar

Picked up an ugly lot on E.
This little tank needed some love.
The question is about corrosion and how you guys handle it. Is vinegar going to be any better than 0000 steel wool?
I used steel wool and a little polish and then took everything apart for a full look.
The mechanicals are good. I need to replace the posts and the spool eventually. The foot is ugly but not a big concern. Rings cleaned up pretty decent. Fishable ?
-Steve

foakes

Nice save, Steve —-

That little 1/0 is ready to fish!

Best Regards, Fred
The Official, Un-Authorized Service and Restoration Center for quality vintage spinning reels.

D-A-M Quick, Penn, Mitchell, and ABU/Zebco Cardinals

--

You don't work for your tools — your tools have to work for you...
Set up your shop and workspace accordingly and efficiently.

"The Truth is always the Truth, no matter how many do not believe it...And a lie is always a lie no matter how many people believe it."

Donnyboat

Good work Steve, considering the condition it was in, thanks for posting, cheers Don.
Don, or donnyboat

Brewcrafter

That's a pretty big improvement! - john

MACflyer

That looks better than results I get with vinegar. Sold my 1/0 last year. Guy that bought it uses it for surf fishing.
Rick

Two rules on the boat
1. Fish where the fish are
2. See rule #1

thorhammer

Good save, I love those little guys.

OhReely

I recently tried a product that I saw Dennis, 2nd chance tackle videos, use to remove that green crud. Flitz metal prep, spray it on, wait 1 minute, rinse with clear water. It works as advertised.
Had to use a toothbrush in some crevices but overall a great product.

Benni3


sandbar

Quote from: OhReely on September 21, 2026, 02:36:05 PMI recently tried a product that I saw Dennis, 2nd chance tackle videos, use to remove that green crud. Flitz metal prep, spray it on, wait 1 minute, rinse with clear water. It works as advertised.
Had to use a toothbrush in some crevices but overall a great product.

Thank you for the tip!
I just ordered some.
I appreciate you.
-Steve

OhReely

I admire your skill and patience in bringing reels back. I never seem to achieve the results you did with this 1/0. Great job. What I've found to be the hardest to clean are guides on vintage rods. I had good results with the Flitz on a crusty 113H Special Senator I just acquired. I'm going to try it on a rod next.

Maxed Out

#10
 Excellent work bringing that little tank back to life. Your spool is stainless steel, and very capable, so no need to replace it. The click tongue and ring looks unused, which is a bonus, cause penn designed this one as non replaceable. A fresh drag stack and a grease job and you'll be ready to rock & roll !!
Success derives from not repeating failure

Crow

There's nothing wrong with a few "F's" on your record....Food, Fun, Flowers, Fishing, Friends, and Fun....to name just a few !