Avet HX 5/2 Anti Reverse knob part #58

[SushiKing]

Anybody in the Bay Area have Avet HX 5/2 part #58 it's the plastic Anti Reverse part that the spring clip rides in  that the Dog Arm connects to ?

[Keta]

I'm not sure if I have one but will look tomorrow.

[SushiKing]

Thanks for the reply Keta. The reel I am working on has a small chip in part #58 so when your reeling it works great but when you stop reeling right at the chip the spring clip for the Reverse Dog Arm pops out of the groove.

[Keta]

I am sure they are the same for all of the non EX reels but can you measure the ID and OD?  I had a new one in my parts inventory.

[SushiKing]

12mm.x 19.25mm.

[SushiKing]

Last night I took a O ring for a Shimano Tranx 200 spool tension knob and put it on part #58 and put the smallest dab of grease on the O ring at the chip mixed up 5min. epoxy the epoxy it's kinda soft and you can see it's not sticking to the plastic good but the clip spring is staying in the groove now I am going to the hardware store to find a thin washer to put on top of #58 to help keep spring clip in if epoxy patch falls off.

[Keta]

I would replace it.  Avet is a PIA for parts ordering but I am 99.99% sure they are the same on all of the non EX reels.  I will try to go in to my shop this evening and measure the one I have.

[SushiKing]

Well I got the reel working after several tries but the reel had a clunk while reeling same spot every time. I took it back apart again and watched the gears with my head magnifying glasses and found the bad spot one tooth on big drive gear had a little tweek to it no problem grab my jewelers file to clean it up not even a full pass tooth falls off I think when pinion bearing failed it got tweeked because I could not get pinion gears apart when I started cleaning the reel super bummed because I was fixing reel for a guys son who is going to San Diego to fish

[Keta]

The item #58 I have is the right part.