Penn 113HLW clicker side plate

Started by Ocmacman17, November 15, 2026, 06:20:31 AM

Previous topic - Next topic

OhReely and 1 Guest are viewing this topic.

Ocmacman17

Hello, I have a Penn 113HLW and when I was rebuilding it, I noticed that the clicker side plate had a lot of play in it. When I put the button on for the clicker its ok, but when I simple barely touch the button it stops the clicker. This is the type of clicker that has the button riveted on. It's loose. Can this clicker setup be changed? If so how do I take the clicker button off?

How can I change the clicker and put the one that has the circ clip setup and screws in?
Penn Reels
113H, 113HLW, 114H, 114HL, 114HLW, 505HS, Shimano TLD30, Rival 20LW, Piscifun Chaos X
Squall II 30LD, assortment of Jigmasters

Keta

Support the outside "rivet" and peen the inside until it works properly.
Hi, my name is Lee and I have a fishing gear problem.

I have all of the answers, yup, no, maybe.

A man who carries a cat by the tail learns something he can learn in no other way.
Mark Twain

Surfrat

Yes, I recalled Mysticparts and other sellers have the replacement parts that you need to upgrade it to using a clip to secure the clicker. Modern 113H sideplates use a click button secured with a small E-clip or C-clip. To replace it, you simply pop off the clip, swap the click tongue/button, and secure it back.


OK, this is if you want to replace the clicker that has been peened on.  ::)


1. Take the sideplate off and set it on a table.

2. Get a Dremel or comparable grinding tool and chuck up a grinding bit.

3. On the inside of the plate, you will see a small circle where the click button has been peened onto the clicker.

4. This is the part you will neet to grind out. Before you start grinding, remember to wear eye protection.

5. Get a small punch/nail set of some sort and once all of the button has been ground away, carefully drive the button out of the tongue.

6. GOOD LUCK!