Penn 113H 7+1 Drag Set

Started by Bryan Young, September 05, 2013, 12:36:04 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

How many of you would be interested in a 7+1 drag set for your Penn 113H?

Yes
10 (83.3%)
No
2 (16.7%)

Total Members Voted: 12

Voting closed: October 05, 2013, 12:36:04 AM

Print
Go Down Pages 1 2 3 4 5
User actions

broschro

#60
January 29, 2014, 12:13:10 AM
I put Bryans kit in my accurate gears all is good.I haven't got to try I'm on anything huge yet,but I will let everyone know after ny first 40-50 pound amberjack and Cobie I catch this spring 8)

Bryan Young

#61
January 29, 2014, 02:45:54 PM
Quote from: maxpowers on January 28, 2014, 10:55:09 PM
Does anyone have a problem with the eared washers bending?  I have 1 washer that is severely bent.  I think I can pound it back out.
you have a bending on one of my sets?
:D I talk with every part I send out and each reel I repair so that they perform at the top of their game. :D

erikpowell

#62
January 29, 2014, 10:09:47 PM
Quote from: Newell Nut on January 28, 2014, 11:40:05 PM
Guys I do something a little different on my spacing in the gear. Since I cut a lot of my own CFs I start with .6mm CF for 3 and then finish using two .5mm CFs and they stack nice.
In my larger reels I would use 5 of the .6mm CF and then two .5mm CF for a 7 stack.
I think by using the .6 in the bottom two layers that I make sure my eared washer does not bottom out.

Bullseye!  x 2  ...when i looked closely at my gear, i wondered how that first eared washer wouldn't bottom out... I did the same thing, thicker CF on the bottom 2, thinner on top.
Print
Go Up Pages 1 2 3 4 5
User actions