Surfmaster 200

[JasonGotaProblem]

yea.. i forgot to mention that i need
the diameter for the tool to remove that pin...

Ahh very different problem. It doesn't need to be the right diameter . It just needs to be smaller. A finish nail works well. Some folks use a jewelers watch band tool. One fellow I know has a hole drilled at the edge of his bench and he taps it thru with a small nail. All you need to do is get it started and then pull out with a pair of pliers.

[dubsetter]

yap..
it needs to be smaller.. thats why i asked.

i ordered now a 0.9 mm tool (pin punch)

as i have a lot of tweezers, screwdrivers,pliers  etc..
but missed to buy a set of these.

anyway thanx ..
 
i will report when the conversion is done.
(might take a while though, as the bridge /sleeve will
be shipped overseas which will take at least two weeks.)