Dip or drip TSI 321

[OkobojiEagle]

I've read it both ways on these boards so I'm slightly confused.  Is it best to dip bearings and/or parts into TSI 321 then blow off excess, or lightly drip TSI 321 onto/into bearings and/or parts then blow off excess?  To be clear, I'm referring to TSI 321 not TSI 301.

oe

[Bryan Young]

Either is fine, but for TSI321, I tend to drip and spin the bearing slowly.  I just leave the excess on there and it will eventually spin out excess when the bearing spins.

[Chris Gatorfan]

I do the drip also. It believe by doing the dip and spin that it allows the bearing to fully lube themself properly. thats just my opinion.

[alantani]

drip......   

[Tiddlerbasher]

Drip x2.
OR dilute the TSI321 with IPA (Isopropryl alcohol 99%) 20% TSI321 80% IPA. Works just like TSI301 (but muuuuch cheaper). Simple dunk the CLEAN bearing in the solution then fit. The IPA evaporates leaving an optimal coating of the TSI321