112 and 113 Black reel clamp bolts

[Shark Hunter]

I'm making up some Plinths for Bluefish. What is the width, center to center of a 3 and 4/0 Black, reel clamp bolts? I don't have either. Don't know if the H series is the same or not.

[Irish Jigger]

30-113= 1 3/8" (1.375").

[Shark Hunter]

Thanks Tom. What about the 3/0 Black? Anybody?

[Irish Jigger]

FWIW the 30-66 (112H) is identical to the 30-113.

[BMITCH]

Daron, the 30-66 is 1.400" on center. With calipers and eyeballed.
Bob

[Shark Hunter]

Thanks Bob.

[Ron Jones]

I hope I am not being taken offensive when I point out that it would take quite an eye to tell the difference between 1.375' and 1.400'. I'd say they are the same.
Ron

[BMITCH]

Only depends on how much you had to drink! right you are!

[Irish Jigger]

I think you are right Ron.
I had a double Bushmills before I measured mine using a tape measure
Remembered that the old Penns were Imperial and usually quoted spool widths and plate diameters to the nearest 1/16 inch.
Anyway we'll not argue over 25thou .
Now it's all gone Metric.
Still waiting for someone to measure a 30-112 Stand  for the OP.
Guess it's the same as the 112H.
Good Luck with the Plinth Shark Hunter.

[Ron Jones]

The stand for the 112 and 112H are totally different. I can measure this evening, which is early tomorrow morning for most of you.
Ron

[john2244]

The stand for the 112 is different from the 112H but the hole pattern is the same.  Center to center is approx 1 3/8".

John

[Shark Hunter]

I'll drill both of them at 1 3/8". Thank you Gentleman!