horrors!!!! i now own 100 left handed 6/0-9/0 stainless steel gear sleeves!!!!

Started by alantani, February 02, 2015, 02:39:40 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Shark Hunter

I have it on a rod and spooled with 80lb mono, but its dark now. I will continue my testing tomorrow.
Randy told me the super six was the same width as the WEX. It is on the outside. The Wex frame is 3/8" wider on the inside.
3 1/2" verses 3 7/8".

Life is Good!

Alto Mare

Very good! give it hell Daron. I also believe the ratchet will do just fine, the only speculation I have is that the tip of the teeth will eventually get rounded a little and that's a good thing.
This will not happen during your test, it should take a while.

Thanks for your hard  work, I'm sure it will be appreciated by all.

Sal
Forget about all the reasons why something may not work. You only need to find one good reason why it will.

Shark Hunter

First test was a 20lb ammo can. I picked it up several times, to put pressure on different areas of the ratchet. Its did fine.
I then hooked it to the riding mower and made a few pulls to heat the sleeve and drags up. No issues.
I have five more of these sleeves and won't hesitate to use them.
I was really impressed with this blank. It is a Penn Mariner stand up 30-80. I thought it would have bent more.
I wanted to add more weight, but afraid it would snap.
Life is Good!

conchydong

Daron, we need to get you one of these simulators for your testing.


Shark Hunter

Life is Good!