Tiagra 130A from kamuwela!!!!!

[alantani]

We have a brand new Shimano 130A, grab a schematic & follow along.


Remove push button shield #91 & two screws #92


Remove slide plate #94 & handle bolt plate #2A


Remove push low button shaft #740 & handle assembly #741


Remove drive shaft shield


Remove lever hub cover #414 & lever quadrant #743


Remove right side plate B #746


Right side plate B & drive gear assembly


Pinion gear & alert ratchet #750


Main gear assmebly with inner & outter bearings #578 looks dry for my liking but it was lubricated
with a liquid lube


Remove spool #751


Left side plate #758


Remove harness lug #756


Remove stand #459


Remove stand shield #458


Okay, here we go. This is my theory of corrosion protection. These reels arent cheap i
guess im just picky. It should last a life time.


Grease all screw holes to prevent salt intrusion


I like to also to brush screws with grease


Torque them down & wipe away excess grease


Lightly grease all screw holes, one piece #757. Dont use too much grease, prevent frame
cracking tighten screws slowly & torque tight


Grease frame & install harness lug


Repack all bearings


Lightly coat left side plate just more salt protection


A light coat of grease & a bead for a seal along the outter edge


Grease screw holes for more protection


Install left side plate cover & wipe off excess grease


Remove cross pin #441 & preload springs #444


Remove anti-reverse ratchet #461


Remove cooling shield #754


Remove outter drag washer & drag plate #752


Two shims & liquid lubed bearings. dont think i'll be casting this real so i'll just repack bearings


Note: four pressure release springs #448


Repacked spool bearing #577


Greased drag washers inner & outter #454 & #449


Wipe off excess grease


Insert pressure plate A #449 & grease pressure release spring #448


Lightly grease O ring & cooling shield #754


Install pressure plate B #454


Install anti-reverse ratchet #461 & shim


Reinstall right side pinion assembly. note: this reel 2 shims then spring washers.
washers were reinstalled using stock configuration ((((|


Install completed spool


Going to lightly grease main gear assmebly & repack bearings


One drop of corrosion X on alert plunger #749


Lightly grease shaft, install shim on drive gear B #438 drive gear A #437


Salt protection complete


Installl lever quadrant #743,drag control lever #745 & lever hub cover #416


Grease drive shaft shield #409 & install with drive shaft thrust washer #410 & #411


Reinstall handle


Note: little spring, dont lose it. Install handle bolt plate 2A, slide plate #94, slide plate
spring #93, & push button shield #91




Now that wasnt so hard was it? There were a few little springs here & there that could
be lost easily. These are great reel in my opinion, could use more lubrication from the
factory. I mean i dont think too many guys will use these reels for casting. If you look
at a previous tutorial i did, you can see the beating these reels take here in Hawaii. For
me, its all aout protecting the investment.
                                                         Aloha, Kamu
                                                           Honolulu