DAM Quick 220 N - - Question about a washer

Started by festus, October 31, 2017, 03:21:42 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages1
User actions

festus

October 31, 2017, 03:21:42 PM
All my DAM Quick reels have two of these washers except for my 220N. One is between the drive gear and the slide, the other between the slide and c-clip. Every schematic I've seen show only one washer between the slide and c-clip.

My question is can any harm come from using the reel without the washer between the slide and drive gear?

foakes

#1
October 31, 2017, 05:18:25 PM
It will work just fine either way, Festus -- provided it is lubed with grease for proper function -- not too much, not to little..

Best,

Fred
The Official, Un-Authorized Service and Restoration Center for quality vintage spinning reels.

D-A-M Quick, Penn, Mitchell, and ABU/Zebco Cardinals

--

You don't work for your tools — your tools have to work for you...
Set up your shop and workspace accordingly and efficiently.

Don't do what you can do — try what you can't do.
                                    — William Faulkner
Print
Go Up Pages1
User actions