what's coming off the bench......

Ron Jones · May 18, 2021, 03:18:13 PM

I'd wish you luck, but I' certain that's fixed by now.
The Man

alantani · May 18, 2021, 04:51:05 PM

Grudgingly.

Ron Jones · May 18, 2021, 05:13:59 PM

Never had a doubt

alantani · June 18, 2021, 06:32:57 PM

This is why stuff takes so damned long....

Gfish · June 18, 2021, 07:47:38 PM

Maybe you need an apprentice—"boy, take them reels apart fer me..."

alantani · June 19, 2021, 01:29:06 AM

And another!!!

thorhammer · June 21, 2021, 03:53:14 PM

How'd you get that sheared screw out?

alantani · July 03, 2021, 05:34:02 AM

propane torch till it glows....

Shark Hunter · July 03, 2021, 11:25:06 PM

Pow!

Drisse · July 18, 2026, 10:22:31 PM

Quote from: alantani on December 18, 2019, 05:53:55 PMclose ups!

Got a 6500C3 2-speed in pieces from a friend to reassemble. Looked at the schematic and lined up the parts for the stardrag and I think I got it right. Then I found this old post and matched. Just noticed that the thick washer after the bearing has a small edge and that the edge should be against the bearing on the mainshaft if I understand Alans picture right ? Then the belleville washer under the stardrag ) and the one after the stardrag (. Can anyone confirm if I got it right ?