Started by Tate, August 03, 2020, 04:14:41 PM
0 Members and 1 Guest are viewing this topic.
Quote from: Bryan Young on August 03, 2020, 10:30:00 PMHT-100s tend to be a little squishy as they washers are not as dense as Carbontex, and therefore, the drag will not ramp up as quickly.I prefer Corbontex because the drag setting is predictable at lower drag range and can obtain slightly higher drag numbers (like 1-3#) since the washers does not compress.But, I will often mix the washers up to get the proper stack height.Regarding the metal washers, Penn tends to cup a little since they are stamped out whereas SmoothDrag metal washers are flat and ground flat. Flat is better.
Page created in 0.075 seconds with 17 queries.