Mitchell Spinning Reel Socket

[basenjib123]

Does anyone have a Mitchell Socket they want to sell me?  Thanks, Joe.

[handi2]

Does anyone have a Mitchell Socket they want to sell me?  Thanks, Joe.

Could you please tell me what this is?

Keith

[foakes]

If Keith doesn't have one —-

Here is a spare one.

Best, Fred

[handi2]

I'm assuming its for the rotor nut? I didn't know that existed. I just use a metric socket.

Keith

[Gfish]

It's 1/2"(13mm). I have a thin bicycle wrench that's bent at a right angle near the open end. Fits nicely around the spool shaft. Not good for real tight hex nuts, though. This is for the baffle plate/rotating-head nut right?

[foakes]

I seldom use these.

My preferred tool is a Metric nut driver.

I keep a complete set of the Metric's and Standards directly to my right on the bench.

Quick & easy.

Best, Fred

[Midway Tommy]

I use thin walled deep well sockets.I prefer the extra leverage of the ratchet.

If I remember right there are two different sizes of the Mitchell issue wrench.

[basenjib123]

I found one,  thanks for the replies..