Tip rollers

[MexicanGulf]

The Everol project unfortunately failed, the tip rollers cannot be made in size 9. At this point Alps or Winthrop rollers

[boon]

I like the Alps ones very much. The ones with ball bearings rather than bushings are quite maintenance-intensive though.

[mikeysm]

They can make one but not cost effective. Thats why I made a insert on my tip. The everol tip is a straight hole its not tapered. So all I did was I used a piece of aluminum rod and drilled a small started hole and then reamed it out with a taper pin reamer. It fit perfectly and just glued it in the tip. I couldn't find a set with the right size tip.