Penn Torque 5

Started by the_reel_doc, September 03, 2014, 11:05:14 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

the_reel_doc

    I bought a used Torque 5 that the guy said had been only used twice. I got it in and it looked to be as he said with only one little nick on it. I started to reel and as the spool got lower the reel began to tighten up. Right away I figured a bent spool shaft and after a second look could see the spool leaning to one side a bit. Well I had seen a post on here about an upgrade to the washer type shaft so I called Penn and they said I would have to send it in for repairs. Well, I am not called the reel doc for nothing so I decided to order the parts from Scott's. After ordering them I receive a call from them saying one of the parts were on back order so I thought well heck, I am not going to use the reel for surf fishing so I won't be getting any water in it so I said just send me the original shaft. Well it came in and after I pulled it apart I discovered this, which is why I am posting this.


  One pic is of old shaft. No screw hole in crosswind block or shaft. Had a clip behind block holding shaft in place New shaft had a hole, course, I had to turn around and order the block with the hole. Got it done and it's working as it should.

foakes

Interesting, Reel Doc --

What is your guess on how this occurred?

Fred
The Official, Un-Authorized Service and Restoration Center for quality vintage spinning reels.

D-A-M Quick, Penn, Mitchell, and ABU/Zebco Cardinals

--

You don't work for your tools — your tools have to work for you...
Set up your shop and workspace accordingly and efficiently.

"Those who fall and get back up, are so much stronger than those that never fell".

the_reel_doc

Thinking I bought one of the very first runs and they might have had an issue with it and decided to go to the hole and screw. Not sure, but I know the new washer type shaft has the hole in them also. Should have seen me looking for the screw in the original before I noticed the clip!

johndtuttle

Does the reel also have a cross pin under the spool? If it does, then unfortunately you should get the spool shaft that supports a washer and allows for shimming. It makes a better seal for waterproofness as well.

I'm thinking you got a prototype reel sent out to a tester that didn't test it much  ;).