Mitchell 300 Handle Knob #81042

Started by steelhead_killer, February 03, 2019, 04:01:49 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages1
User actions

steelhead_killer

February 03, 2019, 04:01:49 PM
Does anyone have (2) of these?  If I had to I would buy the handle and the knob.

Thanks!

Andy
><)))">

foakes

#1
February 03, 2019, 04:22:52 PM
Just need to know which ones you need, Andy...

Spring loaded crank release or finger screw type?

And if you also want the knobs and knob screws?

Show me a pic of your reels — and I will match up the correct cranks.

Best,

Fred

The Official, Un-Authorized Service and Restoration Center for quality vintage spinning reels.

D-A-M Quick, Penn, Mitchell, and ABU/Zebco Cardinals

--

You don't work for your tools — your tools have to work for you...
Set up your shop and workspace accordingly and efficiently.

Don't do what you can do — try what you can't do.
                                    — William Faulkner

steelhead_killer

#2
February 03, 2019, 08:43:30 PM
Really just need the knobs as I have the screws already.  Photo attached.

Thanks Fred.

Andy
><)))">

foakes

#3
February 03, 2019, 09:43:43 PM Last Edit: February 03, 2019, 09:44:49 PM by foakes
Here are a couple, Andy —

Just PM me your full mailing information — and I will drop them off at the PO tomorrow.

N/C.

Best,

Fred
The Official, Un-Authorized Service and Restoration Center for quality vintage spinning reels.

D-A-M Quick, Penn, Mitchell, and ABU/Zebco Cardinals

--

You don't work for your tools — your tools have to work for you...
Set up your shop and workspace accordingly and efficiently.

Don't do what you can do — try what you can't do.
                                    — William Faulkner

foakes

#4
February 04, 2019, 01:03:18 AM
Got your info, Andy —

Addressed and ready to drop off tomorrow.

Best,

Fred

The Official, Un-Authorized Service and Restoration Center for quality vintage spinning reels.

D-A-M Quick, Penn, Mitchell, and ABU/Zebco Cardinals

--

You don't work for your tools — your tools have to work for you...
Set up your shop and workspace accordingly and efficiently.

Don't do what you can do — try what you can't do.
                                    — William Faulkner

steelhead_killer

#5
February 04, 2019, 04:10:30 PM
Thank you! 

Andy

Quote from: foakes on February 04, 2019, 01:03:18 AM
Got your info, Andy —

Addressed and ready to drop off tomorrow.

Best,

Fred


><)))">
Print
Go Up Pages1
User actions