4200SS Pinion Bearing retaining ring

Started by bja105, November 18, 2024, 01:57:36 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages1
User actions

bja105

November 18, 2024, 01:57:36 AM
I have a Penn 4200SS I have owned since new. It is a bit gravely, so I got a new set of bearings. I am struggling to get the clip out to remove the pinion bearing. It is a split ring, no ears. I always struggle with these type. I tried fish hooks, I had a 15 year old try.  Any tips?

Jason

foakes

#1
November 18, 2024, 04:26:30 AM
Hi Jason —-

I use a strong hook on one side to keep the retainer from rotating —- then an old pocket knife with a thin blade to remove the retainer on the opposite side.  Just need to get it started and it will pop out.

Don't let it get away from you by entering a low earth orbit.

Best, Fred
The Official, Un-Authorized Service and Restoration Center for quality vintage spinning reels.

D-A-M Quick, Penn, Mitchell, and ABU/Zebco Cardinals

--

You don't work for your tools — your tools have to work for you...
Set up your shop and workspace accordingly and efficiently.

"Those who fall and get back up, are so much stronger than those that never fell".

bja105

#2
November 22, 2024, 01:35:39 AM
I got it with a hook. there were two split rings, one much thicker than the other. the both came out easily today.
The new bearings made the improvement I had hoped for. this reel is new again.

foakes

#3
November 22, 2024, 01:37:23 AM
Great!

Best, Fred
The Official, Un-Authorized Service and Restoration Center for quality vintage spinning reels.

D-A-M Quick, Penn, Mitchell, and ABU/Zebco Cardinals

--

You don't work for your tools — your tools have to work for you...
Set up your shop and workspace accordingly and efficiently.

"Those who fall and get back up, are so much stronger than those that never fell".
Print
Go Up Pages1
User actions