Reel Repair by Alan Tani

Does anyone have one laying around i can grab from you?

BNT 2200

Shimano has them on back order until MAY!!!! A bit too long of a wait

Any help is very much appreciated!

Geoff

It's a thin hexagonal nut. A metric(?) stainless steel locknut would do temporarily until the proper part becomes available.Just measure the Drive Shaft diameter, forget about the Handle Retainer and go fishing.

i will probably have one.  please send me an email with your shipping info and i will mail it out. 

Quote from: Irish Jigger on January 15, 2013, 08:37:36 PM
It's a thin hexagonal nut. A metric(?) stainless steel locknut would do temporarily until the proper part becomes available.Just measure the Drive Shaft diameter, forget about the Handle Retainer and go fishing.

Just remember that it is a left hand thread so be careful if you do decide to put a stainless steel lock nut in temporarily.

Awesome! Thanks Alan!

Pm Sent.

Thanks for the info guys, but it's not my own reel, or i'd of found something that fits! lol. Thanks

Geoff

found a 10mm left hand nut that will fit the drive shaft, but the questions is the height.  i will try to get it into the mail this afternoon. 

Got it! Thanks Alan.

At least he can get back on the water. Now to try and hunt down a replacement...

Geoff

it was too tall, wasn't it!

Yeah,

i had a right hand thread nut, as well as a right hand thread handle. And i had the same nut at home. No bueno, JUST too tall. Very much appreciated anyway

Geoff