Started by Porthos, March 19, 2015, 03:52:35 AM
0 Members and 1 Guest are viewing this topic.
Quote from: Rothmar2 on February 16, 2018, 05:47:36 AMCheers Eugene, I think I will order A 30H sleeve and see how it goes in the 27. If not quite right, will just find a 30H and put it in that.
Quote from: Rothmar2 on February 16, 2018, 10:42:00 PMHi PorthosI really should check what I have stashed in boxes more often! I actually have a 30H. Don't know why I had it in my head it was a 27H. Anyway, I'm pretty sure there has never been an aftermarket stainless sleeve made for these mini-Sealines. But would be chuffed to hear otherwise. The sleeve has a step for the handle nut which screws down around outside of the sleeve. The step is 7mm across the flats, 9mm diameter and 6.5mm high.The main part of the sleeve which the gears and drag star seat/screw over is 10mm across the flats and 12mm diameter. Total length of the sleeve appears to be 41mm. I say appears, as I just haven't got the time to disassemble the bridge completely at the moment. So I have only measured what I can with the bridge in place in the right side plate. The bridge shaft measured from the top of the sleeve is 5.5mm.I'm guessing the Cortez Conversions 300H sleeves will not suit these smaller reels. I will edit this post when I get some time to remove the bridge and completely measure the sleeve.
Quote from: jigmaster501 on February 15, 2018, 11:41:23 AMI will have to give that a shot with the files.I guess we need Tom to make gear sleeves for these now..lolIt would be nice if the gear sleeves were made to fit penn handles....Rothmar, I don't know about the 27H. my friend has a 27H and a 30H and believes they are the same gear sleeve.ThanksEugene
Page created in 0.065 seconds with 18 queries.