Strange looking washer

Started by Alto Mare, January 09, 2012, 11:32:17 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages 1 2
User actions

Dominick

#15
January 12, 2012, 05:06:41 PM
Sal:  I wondered over the dimpled washer.  Actually I believe that it has a purpose.  I bet that this was an experimental washer.  Consider this: The underside of the dimpled washer is machined flat (or formed flat).  This is the working side of the washer and would be the side that presses on the drag material.  During a run the drag system will heat up.  The dimpled side would allow for heat dissipation by letting air circulate around the other side of the washer.  What do you think? Dominick
Leave the gun.  Take the cannolis.

There are two things I don't like about fishing.  Getting up early in the morning and boats.  The rest of it is fun.

Alto Mare

#16
January 12, 2012, 10:10:58 PM Last Edit: January 12, 2012, 10:12:28 PM by Alto Mare
Dominick, that does make sense to me. Typical lawyer, digging in for the right answer ;D.
Forget about all the reasons why something may not work. You only need to find one good reason why it will.
Print
Go Up Pages 1 2
User actions